How to debug the plastic Thermoforming machine?

How to debug the plastic Thermoforming machine? Today we are going to talk about this topic. The plastic Thermoforming machine should be debugged properly in use. How to debug the plastic Thermoforming machine? Let's take a look together!
Step 1: Open the chassis door, thread the compressed air pipe through the small hole at the bottom of the chassis, and then insert it into the air pressure regulating valve inlet connector behind the chassis door, and fix it with a pipe clamp.
Step 2: Close the cabinet door, open the air source switch to input compressed air, and the machine pressure plate will automatically rise.
Step 3: Install the bakelite mold or mold board on the horizontal platform of the disc, and connect the wires on the mold board to the wiring post in the middle of the machine horizontal platform.
Step 4: Connect the nodes of the vacuum molding machine, open the main switch of the machine circuit, and connect the entire electromechanical circuit.
Step 5: Adjust the current conversion switch and power on time, and select the appropriate heating current range and heating time according to the actual packaging situation.
Step 6: When the temperature of the suction molding machine reaches the specified value, start working and complete debugging (rotate the rotary disc, and when the mold reaches the specified position, the pressure plate will automatically press down)
Through the introduction of the plastic Thermoforming machine manufacturer above, you should know how to debug the plastic Thermoforming machine!